Page Not Found!

Sorry. The page you are looking for does not exist. Try using the search bar or read some of our blog articles below.

Semi Conductor

The Top Five High Current PCB Design Tips

Working with high power circuits does involve some different PCB design techniques, such as the width and weight of the copper that is used on the board. Let’s take a look here at some of the most important high current PCB design tips that you should know about to avoid any unnecessary drama.

READ MORE
pcb hole size tolerance

What is PCB Schematic Capture?

Each circuit board that you see being produced by a PCB contract manufacturer first started its life as a schematic. Someone placed the symbols on the schematic and connected nets to the symbol pins in order to create the design data that would drive the layout of the PCB. Let’s take a closer look at what PCB schematic capture is, and some of the do’s and don’ts that you need to be aware of as you design your printed circuit boards.

READ MORE
wire harness manufacturing process

Primary Advantages of Box Build Manufacturing With PCB Contract Manufacturers

The advantage of using the PCB contract manufacturer for the box build is that they are already equipped to handle this level of project management and documentation support. Not only are they used to working with multiple outside resources for parts and materials acquisition, but they also have the engineering and manufacturing staff to handle the mechanical design and build as well. This gives them another advantage over using multiple vendors, which is that all aspects of the box build will be controlled in one location.

READ MORE
tombstoning pcb assembly

PCB Copper Balance Concerns to Know for Manufacturing

Circuit boards can get out of whack too, and when that happens they can bend and twist in ways that are not good for the board. This effect happens when some areas of the board have more copper than others. To prevent this, it is a good idea to even out the amount of copper fill used between the different open areas of the board. Here is some more information on why this problem occurs, and what you should do to ensure that your circuit board has good PCB copper balance.

READ MORE
PCB layout constraints

Selecting High Mix, Low Volume Contract Manufacturing for Your NPI Electronics

In order to make sure that your new product introduction is a success, you need to look at a manufacturer’s quality, their reputation, and what their capabilities are. Without fully looking into a manufacturer first, you may find out that your costs end up being much more than you initially bargained for. Here are some ideas on how you can find the best high mix low volume contract manufacturing for your electronics new product introduction.

READ MORE